Vector VN5610 - 2.6.2 Connectors USB Side

2.6 VN5610A
Manual VN5610/VN5610A Version 2.0 27
2.6.2 Connectors USB Side
Device connectors
ACT SPEED
Figure 16: Connectors on the USBside
> Power/sync (Binder connector)
The VN5610A has one power/sync connector (Binder type 711) which can be used
for time synchronization of different Vector devices (see section Time Syn-
chronization on page 43) or for power.
Pin Assignment
1 Power supply (6 V … 50 V DC, typ. 12 V)
2 Synchronization line
3 Ground
3 1
2
> IO (Lemo connector)
The VN5610A has a Lemo connector (CH5) for dedicated digital input/output
tasks. The pin assignment is as follows:
Pin Assignment
1 Digital input/output (see technical data)
2 Ground
1
2
Digital Input/Ouput
Isolation
455R
Ri
50R
50R
Vcc
GND_ISO
Passive
Network
From Processor
To Processor
GND_ISO
10k
Figure 17: Digital input /output