3.2 Device Configuration
Manual VN5610/VN5610A Version 2.0 35
3.2 Device Configuration
Configuration Before the installed device can be used in an application, it must be properly con-
figured for the needed use case. This configuration is done with the Vector Hardware
Config tool which comes with the driver installation. The tool can be found in Win-
dows | Start | Settings | Control Panel | Vector Hardware and manages all
installed Vector devices.
Reference
Further details on Vector Hardware Config can be found in the installation instruc-
tions (see section Vector Hardware Configuration on page 38).
Device configuration If you want to change the Ethernet configuration, select a connected
VN5610/VN5610A from the list and double click on Device Configuration.
Figure 19: Vector Hardware Config
Figure 20: Device Configuration dialog
To Next Page
Loading...