5-3
Brake Pad Wear Inspection
The front and rear brake pads should be inspected
regularly for wear. Visually inspect the brake pads
by looking at the remaining friction material through
the sides of the brake calipers. If either the front or
rear brake pads are found to be worn, contact your
authorized Vectrix dealer. Do not drive your scooter
with worn brake pads as this can cause your brakes to
fail resulting in an accident.
Front Brake Pads:
The front brake pads have a wear indicator (A)
built into the friction material of the
pads. When this indicator is no longer visible, the
brake pads are worn and need to be replaced.
LOWER
A
B
C
A
Inspect the level of
the brake uid through
the sight glass (B). If
the uid level is visibly
below the low level
indicator (A), brake uid
must be added. Clean
any dirt or debris from
the cover (C) before
opening the reservoir.
1. Remove the two Phillips screws securing the
cover onto the reservoir, and remove the cover.
2. Add new DOT 4 brake uid.
3. Inspect the cover seal, ensuring that it is free of
any wear or damage and that it is positioned
correctly.
4. Install the cover and tighten the Phillips screws.
To Next Page
Loading...
