5-2
General Maintenance
Brakes
Brake Fluid Level Inspection
WARNING: Do not spill brake uid on painted surfaces,
the nish could be damaged. Spilling brake uid on the
body plastics will cause them to crack. Clean off any
brake uid spills immediately.
Always place a shop towel under the master cylinder
reservoir prior to removing cover.
Low uid levels may indicate worn brake pads or a
leak in the hydraulic system. Inspect the brake pads for
wear and/or the hydraulic system for leaks. Use only
new DOT 4 brake uid from a sealed container.
The brake uid should be ushed out and replaced
every two (2) years.
Battery
WARNING: You must leave your scooter on the
charger if you expect it to sit in storage or unused for
more than one (1) month.
Please leave your Vectrix scooter plugged in whenever
possible.
1. The battery is a Lithium-Ion Phosphate system.
While it does require charging, it does not require
maintenance.
2. The battery should be kept away from excessive
heat. The silicon/lead cells should not get above
71°C (160°F). Do not store in a hot trailer.
3. Only your authorized Vectrix dealer is qualied to
have access to and troubleshoot the battery.
4. Dispose of the battery according to your
state and local laws.
To Next Page
Loading...
