Vectrix VX-1 - Battery Charging

4-7
Accessory Power Outlet
The accessory power outlet (A) is located inside the
glove compartment. It is for charging of a 12 volt wireless
phone. Lift the cover to access the outlet. Close the
cover when not using the outlet. The device requirements
shouldnotexceed0.5amps(6watts).
A
Battery Charging
CAUTION:
 •Useextremecautionwhendealingwithelectricity.
 Use residual current device (RCD) or ground fault 
circuit interrupter (GFCI) protected AC voltage
outlet.
 • DO NOT use non-grounded electrical plug  
adapters.
 • DO NOT use the charging cord if any part of 
charging cord is damaged.
WARNING:
 • Do not use portable or stationary backup  
generating equipment to charge the scooter; this
may damage the scooter’s charging system.
Only charge from a utility supplied voltage source.
 The appropriateAC voltage should be 120v/60Hz
 or 220v/50Hz.
 • Vectrix does not advise the use of extension  
cords to charge the scooter. If you use an
extension cord, it must be of the correct size
to avoid excessive voltage drop. The extension
cord should be rated for 20 amps and NO longer
 than 7.6 m (25 ft).