EasyManuals Logo

Vega MINITRAC 31 Quick Setup Guide

Vega MINITRAC 31
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11
3 Mounting
MINITRAC 31 • Foundation Fieldbus
62076-EN-190704
Youcannddetailedinformationonthematerialsandprocesscondi-
tions in chapter "Technical data"aswellasonthetypelabel.
Metric threads
Inthecaseofinstrumenthousingswithmetricthread,thecable
glandsarescrewedinatthefactory.Theyaresealedwithplastic
plugs as transport protection.
You have to remove these plugs before electrical connection.
NPT thread
Inthecaseofinstrumenthousingswithself-sealingNPTthreads,itis
notpossibletohavethecableentriesscrewedinatthefactory.The
freeopeningsforthecableglandsarethereforecoveredwithreddust
protection caps as transport protection.
Priortosetupyouhavetoreplacetheseprotectivecapswithap-
provedcableglandsorclosetheopeningswithsuitableblindplugs.
Thesuitablecableglandsandblindplugscomewiththeinstrument.
3.2 Mounting instructions
Note:
Duringtheplanning,ourspecialistswillanalysetheconditionsofthe
measurement loop to dimension the isotope accordingly.
Yougeta"SourceSizing"documentspecifyingtherequiredsource
activity and containing all relevant mounting information for your
measuring point.
Youmustfollowtheinstructionsinthis"SourceSizing"documentin
additiontothefollowingmountinginstructions.
Thefollowingmountinginformationisapplicableaslongasthereis
nothingelsespeciedinthe"SourceSizing"document.
Youcanndinformationonprotectivebarriersandthemounting
of the corresponding source container in the operating instructions
manualofthesourcecontainer,e.g.VEGASOURCE.
You can mount the MINITRAC 31 in any position. If you have ordered
yourinstrumentwithaleadcoverasaprotectionagainstambient
radiation(optionally),thethesensorisshieldedlaterallyagainstX-ray
radiation. In this case, the radiation can only penetrate frontally.
Fastenthesensorsinsuchawaythattheycannotfalloutofthe
holder.
DirecttheexitangleofthesourcecontainertotheMINITRAC31.
Mount the source container as close as possible to the vessel. If there
aregaps,securetheareawithasafetyfenceandprotectivegrating
so that no one can reach into the dangerous area.
Caution:
Makesurethatthetubeisalwayscompletelylled.Mainlyinhorizon-
tally arranged tube measuring distances, air bubbles or buildup in
thetubecaninuencethemeasuringresult.Measurementshouldbe
preferably through the centre of the tube.
Cable glands
Installation position

Other manuals for Vega MINITRAC 31

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vega MINITRAC 31 and is the answer not in the manual?

Vega MINITRAC 31 Specifications

General IconGeneral
BrandVega
ModelMINITRAC 31
CategoryAccessories
LanguageEnglish

Related product manuals