The supply voltage range can differ depending on the
instrument version.
Data for power supply are specified in chapter "Technical
data".
The backlight of the indicating and adjustment module is
powered by the sensor. The prerequisite for this is a supply
voltage at a certain level. The exact voltage specifications are
stated in chapter "Technical data".
The optional heating requires its own power supply. You can
find further details in the supplementary instructions manual
"Heating for indicating and adjustment module".
This function is generally not available for approved instru-
ments.
3.3 Operation
VEGAFLEX 65 can be adjusted with different adjustment
media:
l with indicating and adjustment module
l with the suitable VEGA DTM in conjunction with an
adjustment software according to the FDT/DTM standard,
e.g. PACTware and PC
l with manufacturer-specific adjustment programs AMS™ or
PDM
l With a HART handheld
The entered parameters are generally saved in VEGAFLEX
65, optionally also in the indicating and adjustment module or
in PACTware.
3.4 Packaging, transport and storage
Your instrument was protected by packaging during transport.
Its capacity to handle normal loads during transport is assured
by a test according to DIN EN 24180.
The packaging of standard instruments consists of environ-
ment-friendly, recyclable cardboard. For special versions, PE
foam or PE foil is also used. Dispose of the packaging material
via specialised recycling companies.
Transport must be carried out under consideration of the notes
on the transport packaging. Nonobservance of these instruc-
tions can cause damage to the device.
Packaging
Transport
10 VEGAFLEX 65 • 4 … 20 mA/HART
3 Product description
31845-EN-080716
To Next Page
Loading...
