Need help?Do you have a question about the Vega VEGAPULS 54K and is the answer not in the manual?
General| Brand | Vega |
|---|---|
| Model | VEGAPULS 54K |
| Category | Accessories |
| Language | English |
Guidelines for sensor installation, including considerations for measuring range and avoiding false echoes.
Mounting instructions for flange antennas, including DIN socket piece and dished tops.
Guidelines for measuring in surge or bypass tubes, including general instructions.
Avoiding false echoes from vessel installations like ladders, struts, and protrusions.
Safety precautions, qualified personnel requirements, and cable selection for sensor connection.
Connection details for Exd terminal compartments in aluminium housing.
System configuration for Ex areas using a separator with an active PLC.
System configuration for Ex areas using a separator with a passive PLC.
Configuration with VEGADIS 371 Ex for Ex areas, including current and relay output.
Configuration for Exd pressure-tight compartments connected to an active PLC.
Configuration for Exd pressure-tight compartments using four-wire technology.
Using the MINICOM module for sensor setup, including error codes and adjustment steps.
Adjusting sensors using a HART® handheld device, including connection to signal conditioning instruments.
List of common error codes (E013, E017, E036, E040) and their rectifying measures.
Details on Ex approvals, intrinsic safety, Exd encapsulation, and SIL conformity.
Scope of the safety manual for VEGAPULS 50 series and its application in safety technology.
Failure limit values (SIL, PFDavg, PFH) for safety functions based on SIL class.
Considerations for low demand, high demand/continuous modes, and defining dangerous failures.
Instructions for SIL parameter adjustment and configuring the processing unit for failure detection.
Ensuring safety functions during operation and performing recurring function tests.
Analysis of failure rates (FMEDA) for VEGAPULS 51-54 sensors, including architecture and time metrics.
Manufacturer's declaration of conformity for safety-related characteristics based on IEC 61508/61511.
To Next Page