Vega VEGAFLEX 86 - Set up the Sensor with the Display and Adjustment Module; Adjustment Volume; Insert Display and Adjustment Module

10
5 Set up the sensor with the display and adjustment module
VEGAFLEX 86 • Modbus and Levelmaster protocol
47614-EN-230605
5 Set up the sensor with the display and
adjustment module
5.1 Adjustment volume
The display and adjustment module is only used for parameter adjust-
mentofthesensor,i.e.foradaptationtothemeasurementtask.
The parameter adjustment of the Modbus interface is carried out via
aPCwithPACTware.Youcanndtheprocedureinchapter"Set up
sensorandModbusinterfacewithPACTware".
5.2 Insert display and adjustment module
The display and adjustment module can be inserted into the sensor
andremovedagainatanytime.Youcanchooseanyoneoffourdier-
ent positions - each displaced by 90°. It is not necessary to interrupt
the power supply.
Proceed as follows:
1. Unscrew the housing lid
2. Place the display and adjustment module on the electronics in the
desired position and turn it to the right until it snaps in.
3. Screw housing lid with inspection window tightly back on
Disassembly is carried out in reverse order.
Thedisplayandadjustmentmoduleispoweredbythesensor,anad-
ditional connection is not necessary.
Fig. 6: Insertion of the display and adjustment module
Note:
Ifyouintendtoretrottheinstrumentwithadisplayandadjustment
moduleforcontinuousmeasuredvalueindication,ahigherlidwithan
inspection glass is required.