Vega VEGAPULS 68 - Parameter Adjustment

14
5 Set up with the display and adjustment module
VEGAPULS 68 • Two-wire 4 … 20 mA/HART
47165-EN-210621
1 2
Fig. 9: Installing the display and adjustment module in the double chamber
housing
1 In the electronics compartment
2 In the connection compartment
Note:
Ifyouintendtoretrottheinstrumentwithadisplayandadjustment
module for continuous measured value indication, a higher lid with an
inspection glass is required.
5.2 Parameter adjustment
1. Go to the menu " Setup" via the display and adjustment module.
2. Select in the menu item " Medium" the medium of your applica-
tion,forexample"Powder/Dust".
3. Select in the menu item " Application" the vessel, the application
andthevesselform,forexample,silo.
4. Carry out the adjustment in the menu items " Min. adjustment"
and " Max. adjustment".
Set parameters