z Install the software
Connecting the Microscope to Computer!! It is must to connect the
Microscope to Computer before software installation.
Insert the driver CD into CD-ROM Drive and this will automatically
display the following interface:
1. Install the driver by clicking install Microscope Driver
The Install Shield Wizard will walk you through the whole process.
Click on the “Next” button to continue.
2. Install the MicroCapture software
Click MicroCapture software and then reboot the system when asked.
3. You can also browse the User’s manual in PDF format and the CD
contents by choosing the corresponding menus.
To Next Page
Loading...
Need help?
General
