CS100 GB 2
PREPARATION
====================================================
ASSEMBLING THE DETECTOR
Assembling your detector is easy and requires no special tools. Just follow
these steps.
1. Turn the stem's lock nut clockwise until it loosens.
2. Lengthen or shorten the stem so when you stand upright with the detector in
your hand, the search coil is level with the ground and about 1/2 to 2 inches
(1 to 5cm) above it with your arm relaxed at your side.
3. Turn the stem's lock nut anticlockwise to lock it in place.
Wire
Wire
Wrong
To Next Page
Loading...
