6
PPS10 Pocket Scope
TM
FCC information for the USA
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Important
This equipment was tested for FCC compliance under
conditions that include the use of shielded test leads between
it and the peripherals. It is important that you use shielded
cables and connectors to reduce the possibility of causing
Radio and Television interference.
If the user modifies the PPS10 oscilloscope or its
connections in any way, and these modifications are not
approved by Velleman, the FCC may withdraw the user’s
right to operate the equipment.
The following booklet prepared by the Federal
Communications Commission may be of help: “How to
identify and Resolve Radio-TV Interference problems”. This
booklet is available from the US Government Printing
Office, Washington, DC20402 Stock No. 044-000-00345-4.
FCC information for the USA
To Next Page
Loading...
Need help?
General
