60
PPS10 Pocket Scope
TM
PC interface
The scope can send the sampled signal data to a
computer with a serial RS232 port (baud rate
57600, 8 data bits, no parity, 1 stop bit and no
handshaking). Connect the scope to an RS232
port on the PC through the included serial cable.
Install and start the PPS10 programme. The
latest version can be downloaded form the web-
site (www.velleman.be).
To establish the communication, call the
setting menu via the Menu button. Use the
joystick to select ‘Send’ under ‘Screen menu’
and press the joystick to activate the commu-
nication. When calling up the menu you will
see ‘Send’ being checked. To break off the
communication, select ‘Send’ and press the
joystick.
Fig 93
Menu
Fig 92
Fig 91
Pc interface
Joystick
Manette
To Next Page
Loading...
