6. CleaningROBOT HP7C / HP10C / HP15C / HP17C
6-5© VEMAG 2004
• Pull the double screw housing/relevant part of the housing right out of
the feed cylinder by hand, holding the housing steady with the other
hand.
• Then check the rear seal in the feed cylinder for traces of oil.
Warning!
You must check the seals of the double screw drive for traces of oil before
cleaning. If traces of oil are present, the double screw drive must be
overhauled or replaced. In this case inform VEMAG Customer Service.
Fig. 6-8
Removing the double
screw housing
To Next Page
