a
00
i2
Hours
Minutes
am/pm
Press the MODE and FAN buttons
at the same time for two seconds
to enter Setup screens.
Press the MODE and
FAN buttons at the
same time to return
to normal operation.
Quick Start Set the Clock and Go
The thermostat is preprogrammed from the factory to operate
one or two stage equipment* without the need for further
programming. To optimize the installation of this thermostat,
follow the instructions in the Advanced Setup section.
Setting the Clock
MODE
FAN
MODE
FAN
Tip: To change hours quickly,
press and hold the FAN
button and press the UP or
DOWN buttons.
During Setup & Programming:
Pressing the UP or DOWN
butt ons will modify th e
flashing selection.
To adjust the
Clock use
* The thermostat is not preprogrammed from the factory to operate
electric heat or heat pump systems. To control these systems,
follow the steps in the Advanced Setup section, page 11.
buttons.
Page 4
To Next Page
Loading...
Need help?
General
