5
www.ventilation-system.com
READ THE USER'S MANUAL BEFORE INSTALLING THE UNIT.
DO NOT LAY THE CABLE IN CLOSE PROXIMITY TO THE CONTROL PANEL CABLE!
WHILE ROUTING THE CONTROL PANEL CABLE DO NOT COIL THE EXTRA LENGTH.
Control panel mounting sequence
• Make a recess in the wall for a mounting box and lay the
cable from the air handling unit.
Recommended cable length
from the wall surface is 90 mm
• Install the mounting box.
• Remove the screws on the panel edge. • Disassemble the panel by separating the frontal part from
the back part.
• Pass the cable into the rectangular opening on the back
part of the control panel and fix the panel on the mounting
box.
• Connect the cable to the control board and install the
frontal part of the panel using the screws.
MOUNTING AND SET-UP
RECOMMENDED CROSS-SECTIONS OF THE CABLE CONNECTING THE CONTROL PANEL TO THE UNIT
Cable cross section ≥ 0.25 mm² ≥ 0.5 mm² ≥ 0.75 mm²
Cable length up to 10 m up to 20 m up to 30 m
To Next Page
Loading...
Need help?
General