Omni 3200 Reference Manual
134 Maintaining the Omni 3200
Maintaining the Omni 3200
Cleaning the Terminal
To remove dirt from your terminal, use a clean cloth dampened with
water and mild soap. To remove stubborn stains, use alcohol or an
alcohol-based cleaner.
Caution: Never use thinner, trichloroethylene, or ketone-based
solvents to clean the terminal because they may cause plastic parts to
deteriorate.
Cleaning the Printer
Every few months, check and thoroughly clean the printer:
1. Be sure the terminal is connected to a power source.
2. Remove the paper roll cover.
3. Remove the paper roll and spindle from the roll cradle. Carefully
cut the paper in the feed mechanism from the roll.
4. Press the paper feed button to remove the remaining paper from
inside the feed mechanism.
Caution: Do not attempt to pull paper out from the back of the
printer. This could damage the paper feed mechanism.
5. Remove any dirt, dust, or scraps of paper that may be adhering to,
or lodged in, the printer parts.
6. Re-install the paper roll.
7. Check the paper roll cover for signs of damage, wear, or warping.
8. Press the paper feed button to advance the paper through the slot
below the serrated metal strip and replace the paper roll cover.
O3200 RM Book.book Page 134 Thursday, April 29, 1999 3:48 PM
To Next Page
Loading...
Need help?
General
