3
To configure the port mode, run the following command:
Main > Manage > FibreChannel > Configure Deduplication <Initiator
| Target> <HBAportid>
The HBAportid is slot number (1-6) and port number (1-2) of the HBA port.
The format is Slot:Port.
4
To show the current port mode configuration, run the following command:
Main > Manage > FibreChannel > Show [Ports]
5
To disable the Fibre Transport Deduplication feature, run the following
command:
Main > Settings > FibreTransport Deduplication Disable
6
Verify that the settings are correct by running the following command:
Main > Settings > FibreTransport Deduplication Show
This following is the output when the feature is enabled:
[Info] Fibre Transport Deduplication is enabled.
This following is the output when the feature is disabled:
[Info] Fibre Transport Deduplication is disabled.
7
Restart the appliances in the FC zone where the physical state of a port change
has changed.
To reduce the times of restarting, restart the appliances after you finish all the
changes.
See “Settings > Network > Fibre Transport” on page 59.
See “Supported Fibre Channel port configurations for the NetBackup 5220 and
5230 appliances” on page 37.
See “Supported Fibre Channel port configurations for the NetBackup 53xx
appliances” on page 47.
See “Supported Fibre Channel port configuration for the NetBackup 5240 appliances”
on page 43.
See “About the HBA port mode configuration table” on page 61.
See “About FTMS reserved HBA ports and the factory default port mode
configuration” on page 32.
73Configuring Fibre Transport on the appliance
Configuring Fibre Transport on a target appliance for optimized duplication and replication
To Next Page
Loading...
Need help?
General
