Table 4-4
FT configuration process for optimized duplication and Auto Image
Replication over FC (continued)
DescriptionActionStep
Select HBA ports and learn about zoning best practices.
See “About zoning the SAN for NetBackup appliances” on page 51.
Determine the appliance HBA WWPNs for zoning.
See “How to determine appliance HBA WWPNs” on page 51.
Create FT storage zones.Step 4
Configure FT settings on the source appliance.
See “Configuring Fibre Transport to other NetBackup appliances”
on page 68.
Configure FT settings on the targe 52xx and 53xx appliance.
See “Configuring Fibre Transport on a target appliance for optimized
duplication and replication” on page 71.
Note: For configuring the NetBackup 5020 and 5030 appliances as
the target appliance, see the NetBackup Deduplication Appliance
Software Administrator's Guide
Configure FT settings for optimized
duplication and Auto Image
Replication.
Step 5
See “How to configure two NetBackup 52xx or 53xx appliances in different domains
for MSDP replication” on page 76.
Configuring Fibre Transport to other NetBackup
appliances
Use the following procedure to configure Fibre Transport (FT) to other NetBackup
appliances.
Note: When the FT for replication to other NetBackup appliances is enabled or
changed, the deduplication storage daemons require a restart. It is recommended
that you first suspend or cancel all jobs before you enable or change this setting.
To configure Fibre Transport to other NetBackup appliances from the
NetBackup Appliance Web Console
1
Log on to the NetBackup Appliance Web Console.
2
Click Settings > Network, then select Fibre Transport.
68Configuring Fibre Transport on the appliance
Configuring Fibre Transport to other NetBackup appliances
To Next Page
Loading...
Need help?
General
