Table 4-5
Steps to configure two NetBackup 52xx appliances in different
domains for MSDP replication (continued)
Task descriptionStep
Add the NetBackup 52xx or 53xx as a replication target by using the root user
and the password that you recorded in Step 2.
For complete details, see the NetBackup Deduplication Guide. Refer to the
following topic in the chapter titled Configuring deduplication: "Configuring a
target for MSDP replication".
4
On the primary side, do the following:
■ Using the MSDP storage unit on the primary NetBackup 52xx or 53xx that is
used for backups, create a storage lifecycle policy (SLP).
■ Create a Replication storage operation for this SLP, using the remote
NetBackup 52xx or 53xx appliance as the destination.
For complete details, see the NetBackup Deduplication Guide. Refer to the
following topic in the chapter titled Configuring deduplication: "Creating a
storage lifecycle policy".
5
On the remote side, do the following:
■ Create an SLP with the exact same name as the one that was created for the
primary side.
■ Create an Import storage operation for this SLP, using the MSDP on the
remote NetBackup 52xx or 53xx appliance as the destination.
6
To use Fibre Transport for replication, you must log on the appliances on the primary
and remote side using the NetBackup Appliance Web Console or NetBackup
Appliance Shell Menu, and do the following:
■ On the primary side, configure the appliance as a source host for replication
over Fibre Transport (FT).
See “Configuring Fibre Transport to other NetBackup appliances” on page 68.
■ On the remote side, configure the appliance as a target host for replication over
FT.
See “Configuring Fibre Transport on a target appliance for optimized duplication
and replication” on page 71.
77Configuring Fibre Transport on the appliance
How to configure two NetBackup 52xx or 53xx appliances in different domains for MSDP replication
To Next Page
Loading...
Need help?
General
