To Table of Content
REVERB adjusts the intensity of the reverb effect. When this control is set fully counterclock-
wise, reverb will be disabled.
CLAP sets the rate as well as the number of individual claps (transient spikes) in a row. At
fully counterclockwise position, just one single spike / clap will be audible.
NOISE controls the color of the noise signal (NOISE parameter) by continuously cross-
fading between pink and white noise. The effect is subtile and will only be audible if
the NOISE knob is turned up.
NOISE adjusts the amount of noise that is blended with the claps. Without adding a bit of
NOISE, the claps will sound quite artical.
RESONANCE determines the intensity of the lter resonance and, consequently, colors the tonal
component of the clap sound in interaction with the FILTER setting.
FILTER sets the cutoff frequency of the low-pass lter. In interaction with RESONANCE,
this control adjusts the timbre of the sound. At increased levels of the Resonance
setting, the effect of NOISE COLOR will grow less noticeable.
COLOR
User Manual DRM1 MKIV18
To Next Page
Loading...
