To Table of Content
Setup
Content
To warrant top-notch quality, we have carefully inspected the DRM1 MKIV before packaging. Still,
there is a tiny chance the unit might have got damaged in transit. Therefore, we ask you to have
a close look at the DRM1 MKIV when unpacking. Do not hesitate to contact us, should there be
anything unusual with the unit or its packaging.
You should nd the following items in the box:
- the DRM1 MKIV
- a power cord
- this manual
- a big deal of fun and passion
Connection and getting started
The DRM1 MKIV is solely a sound module. To coax the best out of it, it needs to be connected
to a sequencer, a computer, or a keyboard as well as to a mixing desk and/or an amplier. After
connecting the module to a mains outlet socket using the supplied lead, set up audio and MIDI
connections as follows:
Setting up audio connections
⚠
CONNECT FIRST, AND THEN TURN ON! To protect your speakers, your audio-
interface, and – last but not least – your eardrums, we urgently recommend
you to set up all cable connections while the equipment is turned off. Do not
underestimate peak levels and possible damage that might occur when plugging
in or unplugging audio cables.
1. The jacks OUTPUT LEFT and RIGHT
o
on the rear panel of the module put out all audio
signals in stereo. Connect these jacks to two line inputs of a mixing desk, a computer audio
interface, or to an amplier using two cables with 6.3 mm jacks (TS). Alternatively (or at the
same time), you may connect headphones to the PHONES jack
y
on the front panel.
User Manual DRM1 MKIV6
To Next Page
Loading...
