Vermona DRM1 MK4 - Page 24

To Table of Content
2. Press one of the TRIG
q
buttons KICK, DRUM 1, DRUM 2, or MULTI to select the desired
trigger option. The selection will be conrmed by triggering the respective instrument
(instrument will sound and its TRIG LED light up).
- KICK – Gate: The trigger inputs make no use of dynamic response. Each incoming trigger
signal exceeding approx. 2.8V will produce a steady output level. The MIDI velocity value
transmitted will be constantly set to 127.
- DRUM 1 – Gate + Accent: Incoming trigger signals between approx. 0.5V and 5V will produce
a steady output level (no dynamic response). Triggers ≥ 5V will produce a constant accent of
11V. The MIDI velocity value transmitted will constantly be set to 63 (no accent) resp. 127
(with accent).
- DRUM 1 – Gate + Dynamic: Incoming trigger signals between approx. 0.5V and 5V will
generate a steady level (no dynamic response). Triggers between approx. 5V and 11V will
generate a dynamic increase in level. Depending on the trigger level, the minimum MIDI
velocity value transmitted will be at least 56, the maximum being 127.
- MULTI – Full Dynamics: Incoming trigger signals between approx. 0.5V and 11V will control
volume dynamically. The MIDI velocity value transmitted will be between 6 and 127, depending
on the trigger level.
When the assignment procedure is done, the DRM1 MKIV will return to normal play mode
automatically.
User Manual DRM1 MKIV24