Versa Networks CSG730 - Mount a CSG700 Series Appliance in a Rack

~|}ïï),2!"/3& "01"46||"/&"0
Planning and Installationïï18
Component Quantity
Power cable 1
65 Watt PoE power adapter (included with PoE NIC module only) 1
Cat 6 cable 1
Cat 5e cable 1
LTE antenna (included with LTE module only) 2 for single LTE module
4 for dual LTE module
WiFi antenna (included with WiFi module only) 2
GPS antenna 1
Rack-mounting ears 2
Screws for mounting ears 8
3.4.3 Mount a CSG700 Series Appliance in a Rack
You can mount a CSG700 series appliance in a four-post 19-inch rack. Two people are required to mount the
appliance.
To mount the appliance, ensure that you have the following tools:
 2*"/~%&))&-0¡Ì¢ï0 /"4!/&3"/
 Tape measure
To mount a CSG700 series appliance in a four-post 19-inch rack:
1. Place the appliance chassis on a flat, stable surface.
2. Check the internal dimensions of the rack with a tape measure. The appliance is 22 cm wide (about 8.6
inches wide) and must fit within the mounting posts.
3. Allow a minimum of 0.5 RU space above the appliance for airflow, to allow hot air to flow out. However, it is
recommended that you allow 1 RU space above the appliance.
Figure 2: Space a CSG700 Series Appliance when Rack Mounting