~|}ïï),2!"/3& "01"46||"/&"0
Planning and Installationïï14
3 Planning and Installation
This article provides general safety standards and warnings regarding to installing or connecting a CSG 700 series
appliances.
3.1 General Safety Guidelines
Caution: Before installing or removing a CSG700 series appliance, ensure that the appliance chassis is
electrically connected to ground. When you are installing or removing an appliance, ensure that you wear an ESD
grounding wrist strap. To put the ESD grounding strap on properly, attach it to an ESD point and then place the
other end of the strap around your bare wrist, making good skin contact. Failure to use an ESD grounding strap
could damage the appliance.
Install the CSG700 series appliance in compliance with the following local, national, and international
electrical codes:
+&1"!11"0
1%"/ ,2+1/&"0+!
Locate the emergency power-off switch in the installation area. In case of an electrical accident, turn off the
power quickly.
Disconnect power to the appliance before installing or removing it.
Disconnect power from the circuit that is being used for the appliance.
If hazardous conditions exist, do not work alone.
If you are working under conditions that might be hazardous to the eyes, wear safety glasses or goggles.
3.2 Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
&+1"/#"/"+ "1%1*6 20"2+!"0&/"!,-"/1&,+ï
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
ï21&,+: Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment.
%&01/+0*&11"/*201+,1" ,)), 1"!,/,-"/1&+$&+ ,+'2+ 1&,+4&1%+6,1%"/+1"++,/1/+0*&11"/ï
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
To Next Page
Loading...
