Vertex Standard EVX-539 - Page 27

EVX-539 OpErating Manual 25
call
Press, (or press and hold), the assigned
PF
key to
send a 2-tone or 5-tone sequential tone.
status sEt
You can change the 5-tone status code using this
function:

Press, (or press and hold), the assigned
PF
key to
change the 5-tone status code.

Enter the 5-tone status code directly from the
keypad
([
0
]
-
[
9
]
key
)
.

Press the
[
D
]
key to store the new number to the
5-tone status code.
status up/doWn
Press, (or press and hold), the assigned
PF
key to
select a 5-tone status code from the pre-dened status
list.
status cHEcK
Press, (or press and hold), the assigned
PF
key to
check the 5-tone receive status code. When you press
this key, the display will indicate the “Message” cor-
responding to the receive status condition per the pre-
dened status list.
dutY
Press, (or press and hold), the assigned
PF
key
to toggle the Duty function of the 2-tone, 5-tone,
MDC1200
®
or Digital Call decoder “On” and “Off”.
When the Duty function is set to “On”, the display in-
dicates “DUTY ON” briey and the user will always
hear (depending on the sub-audio signaling) all traf-
c on the paging channel. The radio will sound the
paging alert when it receives the programmed 2-tone,
5-tone, MDC1200
®
or Digital Call code.
When the Duty function is set to “Off”, the display
indicates “DUTY OFF” briefly and the user will
NOT hear normal radio traffic on the paging chan-
nel. The radio will sound the paging alert and unmute
only when it receives the programmed 2-tone, 5-tone,
MDC1200
®
or Digital Call code.
advancEd opEratIon
FCC ID: AXI11154620
IC: 10239A-11154620