EVX-S24 OPERATING MANUAL 9
BEFORE YOU BEGIN
Battery Pack Removal
1. Turn the radio off and remove any protective cases.
2. Slide the Battery Cover Latch into the “UNLOCK”
side, then remove the Battery Cover.
3. Pinch the top side of the Battery Pack, then pull out
the Battery Pack.
Battery Pack Installation
1. Make sure that the
VOL/PWR
knob powered off, by
turning the knob counter clockwise to a complete stop.
2. Slide the Battery Cover Latch into the “UNLOCK”
position, then remove the Battery Cover.
3. Install the
FNB-V142LI
Battery Pack into the battery
compartment of the transceiver.
4. Re-attach the battery cover by aligning the tabs of the
battery cover with the slots on the transceiver and slid-
ing into position.
5. Slide the Battery Cover Latch into the “LOCK” posi-
tion.
CAUTION
Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries ac-
cording to the instructions.
Do not attempt to open any of the recharge-
able Lithium-Ion packs, as they could ex-
plode if accidentally short-circuited.
Use the Vertex Standard
FNB-V142LI Lithium-Ion
Battery Pack only.
To Next Page
Loading...
Need help?
General
