Vertical Power VP-X Pro - Appendix B - Wiring Harness Contents; The following wire types and lengths are included in the VP-X Pro wiring harness kit (VP-X Sport does not have components for the J8 connector):; The following items are also included:

Page 76
VP-X Installation and Operating Manual
Rev. D (August 5, 2020)
Appendix B – Wiring Harness Contents
The following wire types and lengths are included in the VP-X Pro wiring harness kit (VP-X Sport does not have
components for the J8 connector):
Qty Gauge Length (ft) Color Terminal on one end
1 20 50 wht none
1 22 80 wht none
1 14 10 black none
1 18 20 black none
1 20 40 black none
3 14 20 wht female power connector
8 18 10 wht female power connector
2 18 15 wht female power connector
10 20 5 wht female power connector
5 20 20 wht female power connector
2 18 5 black female power connector
2 20 5 wht male power connector (test leads)
1 24T 3C Sh 20 wht Data line to EFIS and ap position sensor
1 24T 5C 35 wht Pitch and roll trim cable
The following items are also included:
Qty Item
1 8 pin power connector
1 10 pin power connector
1 12 pin power connector
2 25 pin dsub connector
2 25 pin dsub connector hood with thumbscrews
40 D-sub pins (male and female)
1 Rubber boot
1 Pin removal tool (removes pins from power connectors)
2 Diode for battery contactor and starter contactor
2 1K resistor for aux battery voltage and starter annunciator inputs
1 Bag of assorted insulated crimp terminals
An Ethernet crossover cable is included with the system to connect your laptop to the VP-X.