Using and Entering Station Speed Dial Numbers
Each station in the System is allocated memory for 100 Station Speed Dial numbers (bins
000-099) each up to 23 digits each. These numbers are entered at the user's station and
may include several "special" instructions. Special instructions and the corresponding button
are:
• PAUSE will momentarily stop dialing.
• FLASH as 1st digit-Activate dial tone detect.
• FLASH not as 1st digit-The system will generate a flash on the CO line.
• MSG as 1st digit-Send digits as ISDN Keypad Facility message.
• '*' as 1st digit-Display Security, the stored number will not be displayed when used.
• '*' not as 1st digit-Dial Pulse to Tone Switchover, the system will switch from pulse
to tone dialing.
When entering a Speed Dial, a 16 character name may be associated with the number for
Dial by Name.
To place a call using Station Speed Dial:
1. Lift the handset, and press the Speed button/or press the DIR Soft button,
2. Dial '1' for station speed,
3. Dial the desired Station Speed Dial bin number (000-099).
To enter a Station Speed Dial number with CO Line and Name:
1. Lift the handset, and/or press the DIR Soft button,
2. Dial '1' for station speed,
3. Press the ADD Soft button,
4. Dial the desired Station Speed Dial bin number,
5. Select/dial the CO/IP line/group,
6. Dial the desired number to be stored,
OR
1. Press the [TRANS/PGM] button.
2. Press the [SPEED] button.
3. Dial the Speed Dial bin number (000-099)
4. Press the Line button or dial the Line access code.
5. Dial the number to be stored.
6. Press the [HOLD/SAVE] button.
7. If desired, enter a name, see alphanumeric entry chart under Station Speed Dial.
8. Press the [HOLD/SAVE] button.
To Next Page
Loading...
