Push-To-Talk (PTT) Page
SUMMIT IP Phones can be assigned as a member of one or more of the system's nine
Push-To-Talk (PTT) page groups. Users separately log-in or log-out of any one or all
PTT groups to which the phone is assigned. Once logged in, place or receive one-way
page announcements to/from other users who are logged in to the same PTT group.
To log-in to a PTT group:
1. Dial #0,
2. Dial the desired PTT group number (1-9 or 0 for all groups),
To log-out of the PTT group(s):
1. Dial #0, the PTT Log-in/out code,
2. Press the * key.
To place a page announcement to the active PTT group:
1. Press and hold the PTT Flex button,
2. After confirmation tone, make page announcement.
Attendant
To log other stations in to a PTT group;
1. Press the [TRANS/PGM] button.
2. Dial “077”, the Attendant PTT log-in/out code.
3. Dial the desired station range, for a single station dial the station number and „*‟.
4. Dial the PTT group number (“1”~“9” and “0” for all groups).
5. Press the [HOLD/SAVE] button.
To log other stations out of a PTT group;
1. Press the [TRANS/PGM] button.
2. Dial “077”, the Attendant PTT log-in/out code.
3. Dial the desired station range, for a single station dial the station number and „*‟.
4. Dial “*”.
Power Fail Transfer (PFT)
When AC power to the system fails, back-up operation may be provided with back-up
batteries or Power Fail Transfer (PFT). When battery back-up is provided the station will
operate normally. When PFT is implemented, an SLT is connected to a CO line by the
system. This SLT can be used as any normal SLT, providing service while power is out.
To Next Page
Loading...
