Vertiv Liebert APM 300 - Page 44

Chapter 4 Operator Control And Display Panel 31
APM 300 Integrated UPS Single Module And Parallel System User Manual
Menu
Item
Explanation
Load
Sout (kVA)
Sout: apparent power
Pout (kW)
Pout: active power
Qout (kVAR)
Qout: reactive power
Load level (%)
The percentage of the UPS rating load
Crest factor
Output current crest factor
System
Sout (kVA)
Sout: apparent power
Pout (kW)
Pout: active power
Qout (kVAR)
Qout: reactive power
Battery
Battery voltage (V)
Battery bus voltage
Battery current (A)
Battery bus current
Battery temperature
(
°
C)
Battery temperature
Battery remain time
(min)
Battery run time remaining
Battery capacity (%)
The percentage of the capacity of the new battery
Battery boost charging
Battery is boost charging
Battery float charging
Battery is float charging
Battery is not connected
Battery is not connected
Event (active alarm)
Displays the active alarms. For the list of the alarms that may be
displayed on the LCD on the UPS operator control and display panel,
refer to Table 4-9
Records (alarm history)
Displays the alarm history. For the list of the alarms that may be
displayed on the LCD on the UPS operator control and display panel,
refer to Table 4-9
Language
(language option)
Provides 12 optional LCD languages
Settings
Display contrast
Adjusts the LCD contrast
Date format set
Three formats selectable: MM/DD/YYYY, DD/MM/YYYY, YYYY/MM/DD
Date & time
Sets the date and time
Comm1 baud rate
Sets the communication baud rate of the RS232 port
Comm2 baud rate
For internal communication. Not settable
Comm3 baud rate
Sets the communication baud rate of the SIC card ports
Communication
address
Applicable to RS485 communication
Communication mode
Set the communication mode
Callback times
If the communication mode of the Intellislot 1 port is modem mode, this
parameter sets the number of times of a number is redialed to send an
alarm notification
Phone No.1
If the communication mode of the Intellislot 1 port is modem mode, this
is the first phone number to be dialed (to send an alarm notification)
Phone No.2
If the communication mode of the Intellislot 1 port is modem mode, this
is the second phone number to be dialed (to send an alarm notification)
Phone No.3
If the communication mode of the Intellislot 1 port is modem mode, this
is the third phone number to be dialed (to send an alarm notification)
Command password
Sets the control password. Set by commissioning engineer
Protocol
Sets the communication protocol: Velocity, YDN23. However, because
no optional communication cards of the UPS support Velocity, users can
only select YDN23