Mechanical Installation
Vertiv | Liebert CRD10 | User Manual 48
Table 3-11 Quick check list of refrigerant and oil filling amount
NOTE: “-” represents no need to fill oil.
3.10 Adjusting the Supply Air Baffle and Sealing the Holes
3.10.1
Adjusting the supply air baffle
Adjust the installation direction of the supply air baffle to lead wind to the left or right depending on the
installation location of the Liebert CRD10 models air conditioners. The supply air baffle is composed of
several pieces. Remove the screws on both sides of the single piece of the supply air baffle, rotate it by 180°.
Install it back to change the wind direction. Figure 3-24 shows the mounting screws of a single piece of the
supply air baffle.
Figure 3-24 Fixed Mode of the Supply Air Baffle