Why does my Vertiv UPS have reduced battery backup time?
If your Vertiv UPS has reduced battery backup time, ensure it's plugged in continuously for at least 24 hours to recharge the batteries. Also, check the load level indicator and reduce the load if the UPS is overloaded. If the batteries are old, consider replacing them. Contact your Vertiv representative or Vertiv Technical Support for a replacement battery kit.
What to do if my Vertiv UPS fails to start?
If your Vertiv UPS fails to start, it might be due to a short circuit or overload. Turn off the UPS, disconnect all connected devices, and ensure nothing is stuck in the output receptacles. Also, verify that the connected devices are not faulty or shorted internally. Alternatively, the batteries may not be adequately charged or properly connected. Check the internal battery connection and connect it if necessary. If the battery is already connected, allow the UPS to charge for 24 hours by keeping it connected to the input power before attempting to start it again.
What to do if Vertiv UPS fails to start?
If your Vertiv UPS fails to start, it might be short-circuited or overloaded. Ensure the UPS is off, disconnect all loads, and check for obstructions in the output receptacles. Also, verify that the connected loads are not defective or shorted internally. Alternatively, the batteries may not be charged or properly connected. Check the internal battery connection and connect it if necessary. If connected, leave the UPS connected to input power for 24 hours to recharge before attempting to start it.
General| Product Type | UPS |
|---|---|
| Power Rating | 3000VA |
| Output Power Capacity | 2700W |
| Topology | Double Conversion Online |
| Input Frequency | 40-70 Hz |
| Output Power Factor | 0.9 |
| Efficiency | Up to 95% |
| Efficiency Online Mode | Up to 95% |
| Rack Height | 2U |
| Output Frequency | 50/60 Hz |
| Form Factor | Rack/Tower |
| Battery Type | Sealed Lead Acid |
| Communication Ports | USB, RS-232 |
| Weight | 66.1 lbs |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Operating Humidity | 0% to 95% non-condensing |
To Next Page
