Vertiv | +24 VDC Power System User Manual (Section 6013) | Rev. G
SYSTEM OVERVIEW
Preface
This document (Section 6013) provides User Instructions for NetSure™ Power System Model
, Spec.
No.
.
For Installation Instructions, refer to Section 6012 located in the separate INSTALLATION MANUAL and on the
CD (Electronic Documentation Package) furnished with your system.
Refer to SAG581126000 (System Application Guide) for additional information. This document, along with the
complete document set, can be accessed from the CD (Electronic Documentation Package) furnished with
your system.
Refer to PD588705100/PD588705101/PD588705102/PD588705103/PD588705104 (Power Data Sheet) for
Module Mounting Shelf information. This document can be accessed from the CD (Electronic Documentation
Package) furnished with your system.
Refer to UM1R243000 (Rectifier Module User Instructions) for Rectifier Module (PCU) information. This
document can be accessed from the CD (Electronic Documentation Package) furnished with your system.
Refer to UM1C24481500 (Converter Module User Instructions) for Converter Module information. This
document can be accessed from the CD (Electronic Documentation Package) furnished with your system.
For a color MCA Menu Tree, refer to Section 6022. Section 6022 is provided in the separate INSTALLATION
MANUAL and the CD CARRIER MANUAL (it is also provided on the CD).
System Description
A +24V DC @ up to 4000 amperes Power System.
This power system is designed to power a load while charging a negative grounded battery. This power system
is capable of operating in a batteryless installation or off battery for maintenance purposes. The power system
is designed for operation with the negative output grounded.
The NETSURE 700NVBA DC Power System is a complete integrated power system containing rectifiers (PCUs),
converters, intelligent control, metering, monitoring, and distribution. This power system consists of the
following components.
•
The system always includes a minimum of one Distribution Cabinet, which provides DC distribution
through fuses and/or circuit breakers.
Four different sizes of Distribution Cabinets may be ordered to accept from one (1) to four (4)
Distribution Bus Panel assemblies. A variety of Distribution Bus Panel assemblies are available that
provide combinations of load distribution, battery distribution, low voltage load or battery disconnect,
manual battery disconnect, and dual voltage load distribution for use with -48V converters.. The
Distribution Cabinet is factory mounted in the relay rack specified when ordered.
Most of the distribution panels accept either TPS/TLS-type fuse holders or Bullet Nose-type circuit
breakers. TPH-type fuses and GJ/218-type circuit breakers are also available, in ratings up to 600 amps.
To Next Page