Vertiv | +24 VDC Power System User Manual (Section 6013) | Rev. G
MCA SYSTEM ADJUSTMENTS
Adjustment Location and Identification
All system alarm and control circuits intended for customer adjustment are accessible via the local MCA
Interface Pad. Unless otherwise stated, these circuits have been factory set to the values listed in
SAG581126000 (System Application Guide). The SAG can be accessed from the CD (Electronic
Documentation Package) provided with your system. If readjustment is necessary, perform the appropriate
adjustment procedure detailed in this section.
These adjustments can also be done via WinLink software (if furnished). Refer to the online Help Files
accessed within the WinLink program for User Instructions.
Refer to Figure 1 for local adjustment controls locations.
To Next Page
Loading...
