Vertiv NetSure 700NVBA - Page 22

Vertiv | +24 VDC Power System User Manual (Section 6013) | Rev. G
22
MCA
Menu
Tree
Line No.
(Section
6022)
Message Displayed
Associated
with...
Definition
Can this value
be changed?
17 ALM SUBSYS CURR
Main
Alarm Menu
Displays if subsystem (if connected)
current increases to a preset
adjustable value.
No
17A ALM BAT CHG CURR
Main
Alarm Menu
Displays if battery recharge current
limit is exceeded.
No
18 ALM SUBSYS MINOR
Main
Alarm Menu
Displays if a subsystem minor alarm
occurs.
No
19 ALARM MCA/SHELF
Main
Alarm Menu
Displays if an MCA fail alarm occurs. No
20 FUNCTION MENU
Main
Alarm Menu
Moves you to this menu. No
21 NORMAL DISPLAY
Main
Alarm Menu
Moves you to the beginning of the
MCA Menu Tree. "SYSTEM OK" or
"## ALARMS ACTIVE" is displayed.
No
22 LVD ** ACTIVATED
LVD
Alarm Menu
Displays which low voltage
disconnect circuit operated (either
1A, 1B, 2A, 2B, 3A, and/or 3B).
** = the designation of the LVD alarm
(either 1A, 1B, 2A, 2B, 3A, or 3B).
No
23 RECONNECT LVD **
LVD
Alarm Menu
Allows manual reconnection of an
activated low voltage disconnect
circuit.
** = the designation of the LVD
circuit (either 1A, 1B, 2A, 2B, 3A, or
3B). The first activated LVD circuit is
displayed. Press the FUNCTION
SELECT UP or DOWN arrow
pushbutton to display the next or
previous activated, respectively, LVD
circuit. Press the ALARM CUTOFF
and FUNCTION SET ENTER
pushbuttons simultaneously to cause
this LVD circuit to reconnect. At the
"ARE YOU SURE? + -" prompt, press
either the FUNCTION SET YES (+)
pushbutton to reconnect, or the
FUNCTION SET NO (-) pushbutton
to cancel this operation.
Yes, see
"System
Operating
Procedures".
24 MAIN ALARM MENU
LVD
Alarm Menu
Moves you back to this menu. No