Vertiv NetSure 700NVBA - Page 25

Vertiv | +24 VDC Power System User Manual (Section 6013) | Rev. G
25
MCA
Menu
Tree
Line No.
(Section
6022)
Message Displayed
Associated
with...
Definition
Can this value
be changed?
38A TEMP ** NO REPLY
MCA
Alarm Menu
Displays if temperature sensor
communications lost.
** = the designation of the
temperature probe.
No
39 MAIN ALARM MENU
MCA
Alarm Menu
Moves you back to this menu. No
40 NORMAL DISPLAY
MCA
Alarm Menu
Moves you to the beginning of the
MCA Menu Tree. "SYSTEM OK" or
"## ALARMS ACTIVE" is displayed.
No
41 MEASUREMENT MENU
Function
Menu
Moves you forward to this menu. No
42
SET TEST/EQ MODE
or
SET FLOAT MODE
or
TestEq Switch On
Function
Menu
Completing this operation places the
system into the float or test/equalize
mode as determined by the setting
displayed before the "ARE YOU
SURE? + -" prompt.
or
The user tried to set Float Mode
while the external test/equalize input
switch was on.
Yes, see
"System
Operating
Procedures".
43 ADJUSTMENT MENU
Function
Menu
Moves you forward to this menu. No
44 CONFIGURE MENU
Function
Menu
Moves you forward to this menu. No
45 CALIBRATION MENU
Function
Menu
Moves you forward to this menu. No
46 NORMAL DISPLAY
Function
Menu
Moves you to the beginning of the
MCA Menu Tree. "SYSTEM OK" or
"## ALARMS ACTIVE" is displayed.
No
47 PCU## EMERG STOP
PCU
Detail Menu
Displays if Rectifier Module (PCU) in
Emergency Stop Mode.
## = the designation of the Rectifier
Module (PCU).
No
48 PCU## AC FAIL
PCU
Detail Menu
Displays if Rectifier Module (PCU)
AC fail alarm active.
## = the designation of the Rectifier
Module (PCU).
No
49 PCU## HI AC LINE
PCU
Detail Menu
Not implemented in this system. No