In this way, a maximum of 3 blue keys can be programmed by repeating the above
procedure and keeping the indicated times.
Final step-brown key
After extracting the last blue key, insert the brown key again and turn it to «ON» (carry
out this operation within 10 seconds after extracting the previous key). Leave it in this
position for 1 to 3 seconds and return it to «OFF».
Proper programming check
Insert the brown key, disabling the transponder (i.e., by tilting the key hood by 90°),
and turn the key to the «ON» position. Perform the engine starter operation. Ensure
that the engine does not start. Insert the blue key and repeat the start-up operation.
Check that engine starts.
WARNING
IF THE ENGINE STARTS WITH THE BROWN KEY (AND WITH A DISABLED
TRANSPONDER) OR IF DURING THE PROGRAMMING A WRONG STEP HAS
BEEN CARRIED OUT, IT IS NECESSARY TO REPEAT THE PROCESS FROM THE
BEGINNING.
18
To Next Page
Loading...
Need help?
General