03_13
Checking the brake oil level (03_13)
The brake fluid reservoir is equipped with a sight glass «A» made of transparent ma-
terial; the quantity of liquid contained in the sight glass indicates the level of liquid in
the reservoir.
When the sight glass «A» is full, the level inside the reservoir exceeds the MIN level;
when it is partially full, the level drops to the MIN level; when it is fully empty, the level
of fluid in the reservoir is below the MIN level.
The brake fluid level may fall due to wear on the brake pads. In case the pad wear is
below the minimum mark, contact an Authorised Service Centre to have the braking
system thoroughly checked.
03_14
Braking system fluid top up (03_14)
Remove the tank cap «C» after having loosened the two securing screws «B» and
top up with the prescribed fluid only, without exceeding the maximum level.
Under standard climatic conditions, replace fluid as indicated in the scheduled main-
tenance table. This operation must be carried out by trained technicians; take your
scooter to an authorised Service Centre or Dealer.
WARNING
ONLY USE DOT 4-CLASSIFIED BRAKE FLUID. BRAKE CIRCUIT FLUID IS VERY
CORROSIVE; MAKE SURE THAT IT DOES NOT COME INTO CONTACT WITH
THE PAINTWORK.
CAUTION
AVOID CONTACT OF BRAKE FLUID WITH EYES, SKIN, AND CLOTHING. IN
CASE OF CONTACT, RINSE WITH WATER. THE BRAKING CIRCUIT FLUID IS
HYGROSCOPIC, THAT IS, IT ABSORBS HUMIDITY FROM THE SURROUNDING
49
To Next Page
Loading...
Need help?
General