Vespa LXV 125 3V ie 2013 User Manual

02_08
- Insert the key into the ignition key and turn it to «ON».
02_09
- Wait for the engine control telltale light to turn off.
02_10
- To start the engine, pull either of the two brake levers «B-C» and then push the button
«A».
The vehicle is equipped with special starter procedure management. The starter motor
remains active until the engine starts even if switch «L» is released.
Keep one of the two brakes operated (front or rear) so as to not interrupt the starter
procedure.
The throttle grip must remain in the minimum position, because any other position
inhibits the vehicle starter.
The starter motor will remain active for a maximum of 5 consecutive seconds.
29
2 Use

Vespa LXV 125 3V ie 2013 Specifications

General

Brand	Vespa
Model	LXV 125 3V ie 2013
Category	Scooter
Language	English