1.Unpack the appliance, then check and make sure that all the accessories ,
including the ice basket and ice scoop, etc., are complete. Please contact with the
client service department if some accessories are missing.
2.Please ensure the ice maker is level and on a stable table or platform to avoid
malfunction.
3.The incline angle of the ice maker cabinet should not exceed 45°during
transportation or use. Do not turn the ice maker upside down. Doing so could
cause the compressor or refrigerating system to operate incorrectly. Please allow
time for the fluids in the compressor to settle after the ice maker is moved or
transported. Before using the ice maker for the first time, please wait for 2 hours
after the unit has been leveled and positioned in the proper place.
4.The appliance must be placed on a dry and level surface with sufficient
ventilation, far from heat sources such as ovens, heaters and corrosive gases.
Leave a 15cm clearance on all sides of the ice maker for proper ventilation.
5.Do not fill the water reservoir with hot water. This may damage the ice maker. It
is best to fill the water reservoir with water of room temperature or lower.
6.Do not use the appliance in a cold environment (lower than 5℃).
7.Clean the appliance by following the operation of “CLEANING AND
MAINTENANCE” before operate.
1.Ensure that the drain plug at the back of ice maker is closed well.
2.Plug the ice maker into the wall outlet, the “ ” indicator flashes.
NOTE: Please rest the ice maker for 30 minutes before plug if it has been moved.
3.Open the front lid and remove the ice basket.
4.Fill the water reservoir with drinking water.
NOTE: Do not fill above the MAX water level mark.
To Next Page
Loading...
