VEVOR LB160T User Manual (English)

Questions and Answers:

H
haleyhansonAug 14, 2025
Why is the ice block from my VEVOR LB160T Ice Maker thin?
- S
  Shawn TaylorAug 14, 2025
  If the ice block produced by your VEVOR Ice Maker is too thin, several factors could be responsible. First, try cleaning the surface of the condenser, as dust accumulation can cause this issue. Ensure that the ambient temperature is within the recommended range for the machine. Also, check for refrigerant leaks and recharge if necessary. Other potential causes include a broken fan motor (replace it), a blocked spray tube (clean it), or an ice thickness sensor positioned too close to the ice model (adjust the sensor screw by turning it to the right).
B
Brian MooreAug 17, 2025
What to do if the ice can not drop off from VEVOR LB160T?
- S
  Stephanie HillAug 17, 2025
  If the ice isn't dropping off in your VEVOR Ice Maker, the ice thickness sensor might be broken, and you should replace it. Another potential issue is that the solenoid valve isn't opening. Check the electric wire to ensure it's properly connected, and if not, replace the solenoid valve. Finally, the ambient temperature may be too low; ensure you're using the machine within the allowable ambient temperature range.
L
Laurie TaylorAug 21, 2025
What to do if no water flowing on to the ice model in VEVOR Ice Maker?
- P
  Peter HerreraAug 21, 2025
  If there is no water flowing onto the ice model in your VEVOR Ice Maker, the water pump or the PC board may be broken, and you should replace it.
M
Michelle FarmerAug 25, 2025
What to do if the sink is overflow in VEVOR LB160T Ice Maker?
- T
  Teresa ThompsonAug 25, 2025
  If the sink is overflowing in your VEVOR Ice Maker, the water supply solenoid valve or the water level sensor might be broken, and you should replace it.
K
Karen FosterAug 27, 2025
How to fix loose connecting wire of compressor’s starter in VEVOR Ice Maker?
- S
  Shane MarshallAug 27, 2025
  If the connecting wire of the compressor’s starter is loose on your VEVOR Ice Maker, check and fasten it.
J
Jeffrey ShepherdAug 30, 2025
What to do if the starting capacitor of compressor is broken in VEVOR LB160T?
- C
  Charles CurtisAug 30, 2025
  If the starting capacitor of the compressor in your VEVOR Ice Maker is broken, replace it.
F
Felicia MartinSep 3, 2025
What to do if water level sensor is broken in VEVOR Ice Maker?
- P
  patricia75Sep 3, 2025
  If the water level sensor is broken in your VEVOR Ice Maker, replace it.
J
Joel KeySep 6, 2025
What to do if water pump is broken in VEVOR LB160T?
- E
  egarzaSep 6, 2025
  If the water pump is broken in your VEVOR Ice Maker, replace it.
J
Jill WolfeSep 9, 2025
What to do if PC board is broken in VEVOR LB160T Ice Maker?
- M
  Monica KellySep 9, 2025
  If the PC board is broken in your VEVOR Ice Maker, replace it.

VEVOR LB160T Specifications

General

Model	LB160T
Ice Shape	Cube
Water Supply	Automatic
Voltage	110-120V
Frequency	60Hz
Refrigerant	R290
Material	Stainless Steel
Ice Production Capacity	160 lbs/24h
Storage Capacity	33 lbs
Ice Size	0.9" x 0.9" x 0.9"