VEVOR LB265T User Manual (English)

Questions and Answers:

L
Laura ToddAug 15, 2025
Why is the ice block from my VEVOR LB265T Ice Maker thin?
- N
  Natasha RussellAug 15, 2025
  If the ice block produced by your VEVOR Ice Maker is too thin, several factors could be responsible. First, try cleaning the surface of the condenser, as dust accumulation can cause this issue. Ensure that the ambient temperature is within the recommended range for the machine. Also, check for refrigerant leaks and recharge if necessary. Other potential causes include a broken fan motor (replace it), a blocked spray tube (clean it), or an ice thickness sensor positioned too close to the ice model (adjust the sensor screw by turning it to the right).
M
Michael JohnstonAug 18, 2025
What to do if the ice can not drop off from VEVOR LB265T Ice Maker?
- J
  Joshua TurnerAug 18, 2025
  If the ice isn't dropping off in your VEVOR Ice Maker, the ice thickness sensor might be broken, and you should replace it. Another potential issue is that the solenoid valve isn't opening. Check the electric wire to ensure it's properly connected, and if not, replace the solenoid valve. Finally, the ambient temperature may be too low; ensure you're using the machine within the allowable ambient temperature range.
J
James MelendezAug 21, 2025
What to do if no water flowing on to the ice model in VEVOR LB265T Ice Maker?
- R
  Robert TranAug 22, 2025
  If there is no water flowing onto the ice model in your VEVOR Ice Maker, the water pump or the PC board may be broken, and you should replace it.
H
Heather CraneAug 25, 2025
What to do if the sink is overflow in VEVOR LB265T Ice Maker?
- M
  Mathew BradyAug 25, 2025
  If the sink is overflowing in your VEVOR Ice Maker, the water supply solenoid valve or the water level sensor might be broken, and you should replace it.
K
Kelly WadeAug 28, 2025
How to fix loose connecting wire of compressor’s starter in VEVOR LB265T?
- J
  jonathanrasmussenAug 28, 2025
  If the connecting wire of the compressor’s starter is loose on your VEVOR Ice Maker, check and fasten it.
S
Sharon HardinAug 31, 2025
What to do if the starting capacitor of compressor is broken in VEVOR LB265T Ice Maker?
- J
  jason46Aug 31, 2025
  If the starting capacitor of the compressor in your VEVOR Ice Maker is broken, replace it.
T
Tanya Gallagher DDSSep 3, 2025
What to do if water level sensor is broken in VEVOR LB265T?
- S
  Steven JenningsSep 3, 2025
  If the water level sensor is broken in your VEVOR Ice Maker, replace it.
M
Michael FrazierSep 7, 2025
What to do if water pump is broken in VEVOR Ice Maker?
- P
  Paige ShermanSep 7, 2025
  If the water pump is broken in your VEVOR Ice Maker, replace it.
L
Laura KelleySep 12, 2025
What to do if PC board is broken in VEVOR LB265T Ice Maker?
- A
  Ashley OsbornSep 12, 2025
  If the PC board is broken in your VEVOR Ice Maker, replace it.