VEVOR LB440TA - User Manual

Questions and Answers

A
Amy DennisAug 10, 2025
Why is my VEVOR LB440TA not making ice?
- S
  Steven WestAug 10, 2025
  If your VEVOR Ice Maker isn't making ice, several issues could be the cause. First, check the electric wire to ensure it's properly connected. An ice block might be pinning the retained board; remove it to allow the board to return to its original position. Also, inspect the connecting wire of the compressor’s starter and fasten it if loose. If these steps don't resolve the issue, the starting capacitor of the compressor, the PC board, the water level sensor, or the water pump might be broken and require replacement.
T
Tiffany OrtizAug 16, 2025
Why are the ice cubes from my VEVOR Ice Maker so thin?
- J
  jamescolemanAug 16, 2025
  If the ice blocks produced by your VEVOR Ice Maker are too thin, there might be several reasons. The condenser surface might be covered with dust and needs cleaning. The ambient temperature could be too high, so ensure you're using the machine within the allowable temperature range. A refrigerant leak could also be the cause; in this case, check and recharge the refrigerant. Other potential issues include a broken fan motor (replace it) or a blocked spray tube (clean it). Finally, the ice thickness sensor might be too close to the ice model; adjust the sensor's screw by turning it right.
B
benjamin42Aug 22, 2025
How to fix ice that won't drop from my VEVOR Ice Maker?
- J
  jillian70Aug 22, 2025
  If the ice isn't dropping off in your VEVOR Ice Maker, it could be due to a few reasons. The ice thickness sensor might be broken and needs replacement. Also, check the solenoid valve: ensure the electric wire is well connected, and if not, replace the valve. The ambient temperature might be too low; ensure you operate the machine within the allowable temperature range.
R
Robert BallAug 27, 2025
Why is there no water flowing onto the ice model in my VEVOR LB440TA Ice Maker?
- E
  Erika SmithAug 27, 2025
  If there is no water flowing onto the ice model in your VEVOR Ice Maker, the water pump or the PC board might be broken and need replacement.
M
Micheal GraySep 3, 2025
What to do if the sink in my VEVOR LB440TA Ice Maker is overflowing?
- C
  Christina CarrollSep 3, 2025
  If the sink of your VEVOR Ice Maker is overflowing, it could be due to a broken water supply solenoid valve or a broken water level sensor. In both cases, you will need to replace the faulty component.

Summary

Safety Precautions

General Safety Instructions

Essential precautions to mitigate risks like fire, electrical shock, and injury during appliance use.

Basic Parameters

Basic Structure

Installation

Operating Environment Requirements

Specifies required environmental conditions like temperature, humidity, and ventilation for proper operation.

Power Supply

Water Supply Pipe Connection

Step-by-step guide for connecting the machine's water inlet pipe.

Installation Steps

Water Discharge Pipe Connection

Instructions for connecting the water outlet pipe to a sewer.

Leveling the Main Body

Procedure to adjust the machine's legs to ensure it remains level.

Service Instruction

Operational Process and Checks

Covers operation, ice making, ice dropping, auto-stop, and running checks.

LCD Full Page Display

Buttons on Display Board

Details the function and operation of each button on the control panel.

Fault Code Diagnosis

Daily Cleaning and Maintenance

Cleaning Procedures

Covers cleaning panels, condenser, spray pipes, and automatic cleaning.

Trouble Shooting

Ice Making Faults

Diagnoses common issues preventing the machine from making ice.

Sink Overflow Issues

Identifies causes and solutions for water overflowing the sink.

Technical Parameter and Wiring Diagram

VEVOR LB440TA Specifications

General

Model	LB440TA
Ice Production Capacity	440 lbs/24h
Ice Storage Capacity	99 lbs
Power Supply	110V/60Hz
Refrigerant	R290
Ice Type	Crescent
Material	Stainless Steel
Drainage	Gravity Drain
Control Type	Digital
Display	LCD
Climate Type	N
Ice Cube Size	22x22x22 mm
Power Consumption	170W
Dimensions (H x W x D)	340×420×700 mm
Net Weight	25 kg