VEVOR LB440TA - Technical Parameter and Wiring Diagram

- 18 -
TECHNICAL PARAMETER AND WIRING DIAGRAM
A、Technology parameters are on the nameplate.
B、The electrical schematic diagram is on the inner side of the board .
overflow.
broken
Water level sensor is broken
replace it
No water flowing
on to the ice
model
Water pump is broken
replace it
PC board is broken
replace it
The ice block is
thin
The surface of condenser is
covered with dust.
clean it
The ambient temperature is
too high
You should use the
machine in allowable
ambient temperature
The refrigerant leak
check and recharge the
refrigerant
Fan motor is broken
replace it
Spray tube is blocked
clean it
The ice thickness sensor is
too close to the ice model.
Adjust the screw of
sensor(turn right)
The ice can not
drop off.
The ice thickness sensor is
broken
replace it
The solenoid valve is not open
check the electric wire if it
is connected well or not.
Or replace the solenoid
valve
The ambient temperature is
too low
you should use machine in
allowable ambient
temperature