15
(4) Take out balteries if the meter is meant to be not used for a
longtime.
NOTE:
When the LCD displays " ",please replace the battery in tirne
as per below steps.
(I) Screw off the fixing screws. Remove the battery cover.
(2) Take off the two 1.5V batteries and replace with new ones.
Although any type of 1.5V batteries fit the use, iťs better to use
alkaline batteries for longer time operation.
(3) Screw back the fixing screw sand put back the battery cover.
6. TROUBLE SHOOTlNG
If the meter does not work properly, please check the mete ras
following steps. If the problems remain, please contact repairing
center or local dealers.
Fault Solution
No reading on LCD
Turn on the power
• Release the HOLD key
• Replace ballery
signal appears
• Replace ballery
Big error Value
• Replace ballery
• The specifications are subject to changes without prior notice.
• The content of this manual is regarded as correct. If users find
out any mistakes or omissions, please kindly contact
the manufacturer.
• The manufacturer will not be responsible for accidents
or damages caused by improper operations..
• The functions described in this User Manual shall not be
considered as the reason for any special usages.
2016F.N-V0.1
To Previous Page
Loading...
