3
2. SAFETY NOTlCE
Tbe meter is designed to be in compliance with IEC1010-I (EN61010-1), pollution 2,
CAT.III 600V and UL3111-1. Please read this manual carefully before operation.
2-1.SAFETY SYMBOLS
"
"CAUTION: Refer to manual before operation.
"
" Low battery indication.
"
" WARNING: High voltage!
"
"Double insulation.
2-2.SAFETY lNSTRUCTIONS
2-2-1. To avoid damage to the meter or personal injury, please read this manual carefully
before operation, and follow instructions in this manual during operation.
2-2-2. Disconnect all signals and plug offtest leads before opening the case cover.
To avoid electric shock or damage to the meter, water should not be leaked inside.
2-2-3. DO NOT use the meter to do any test before the case cover or screws is fully
Assembled.
2-2-4. DO NOT input any value higher than the rated limit.
2-2-5. DO NOT input voltage to terminals in resistance range.
2-2·6. Turn the power switch to OFF position after use.
2.2.7. To avoid damage by battery leakage, remove batteries before long-term storage.
2.2.8. Voltage above 60Vdc or 30Vac RMS will cause severe electric shock.
2.2.9. To avoid electric shock, be careful when nipping naked testing objects.
To Next Page
Loading...
