Maintenance
62
Cone
Safety concerning maintenance work on the cutting unit
When working on the cutting unit the tractor must be stopped and
secured.
This prevents the machine from suddenly starting to rotate.
If the tractor and the PTO shaft have not been connected in
accordance with the instructions serious accidents causing damage to
limbs can occur.
When working on the cutterbar:
• The tractor engine must be stopped.
• The ignition key must be removed.
• The tractor's PTO must be disconnected.
• The tractor hydraulic system must be disconnected.
• The hand brake must be activated.
External inspection
Every day
»Maintenance intervals« page 52
An external check of the cones is carried out in the following way:
Remove the pin.
Open the guards around the machine's cutterbar.
Remove any dirt from the cone.
Close the guards around the machine's cutterbar.
Fit the pin.
To Next Page
Loading...
