Vicon EXTRA 332 F - User Manual

Questions and Answers

A
Alicia DavisAug 7, 2025
Why is the stubble uneven with Vicon Farm Equipment?
- P
  Patricia HallAug 8, 2025
  If the stubble is uneven when using Vicon Farm Equipment, several factors could be at play. First, increase your driving speed. Also, verify that the tractor RPM on the PTO is at the correct level. Check the knives; if they are blunt or missing, turn or replace them. Finally, adjust the suspension if the balancing springs are too taut.
K
Kelly JeffersonAug 12, 2025
What to do if there are stripes in the stubble with Vicon Farm Equipment?
- N
  nthompsonAug 12, 2025
  If you notice stripes in the stubble while using Vicon Farm Equipment, it could be due to several reasons. Ensure the cutterbar has the correct angle for the crop by adjusting the hydraulic top link. If high skids are fitted on the cutterbar, remove them, provided the field is free of stones. Also, increased speed to prevent crop build-up on the cutting discs. Finally, make sure you are not driving too slowly.
M
mweeksAug 16, 2025
How to fix hydraulic functions that do not work on Vicon EXTRA 332 F?
- W
  Wanda JonesAug 16, 2025
  If the hydraulic functions of your Vicon Farm Equipment are not working, start by checking that the hydraulic hoses are correctly connected to the tractor's outlet. Ensure the tractor hydraulics are engaged and verify that the mechanical safety valve is open.
D
Dr. Stacy SandovalAug 20, 2025
Why does the cutterbar get abnormally warm on Vicon EXTRA 332 F?
- T
  tristan47Aug 20, 2025
  If the cutterbar of your Vicon Farm Equipment gets abnormally warm, inspect the oil level in the cutterbar. If the oil level is correct, consider that you may be using the wrong type of oil, and change to the correct one.
T
Timothy SimonAug 25, 2025
What to do if hydraulic functions seem sluggish on Vicon EXTRA 332 F Farm Equipment?
- F
  franciscomarshallAug 25, 2025
  If the hydraulic functions of your Vicon Farm Equipment seem sluggish, it may be due to an insufficient amount of oil from the tractor. Add sufficient oil from the tractor.
A
Allen WheelerAug 29, 2025
How to raise Vicon EXTRA 332 F Farm Equipment that is hanging too low?
- A
  Albert MartinAug 29, 2025
  To address the issue of the machine hanging too low in the raised position with Vicon Farm Equipment, raise the tractor's front lift device.
W
Wendy LeeSep 2, 2025
How to stop Vicon EXTRA 332 F from leaving wear tracks in the field?
- C
  codyblackSep 2, 2025
  If your Vicon Farm Equipment is leaving wear tracks in the field, it indicates that there is too much downward pressure from the cutterbar. Adjust the suspension to resolve this.